>>14234105so by closing up the computer with a slope (which is at its highest at the back, near to the fans) it is doing this in the very small, small FF computer?
well if i go into the bath and put the shower head to spray into my hand in an "O" as in "OK" sign, then it shoots out of the back. and the speed at which it shoots out all depends on how large the "exhaust" hole is - i think this is the same concept?
and if i put the exhaust under-water, then it will suck the water out of my hand and lower the volume of water in the "O" - to suck water from the front where there is a gap in the "OK" sign the "O" and it will get rid of the water that way
what is more efficient?
ive said i can over-volt the fans to make them faster, or reverse them to have them go backwards
i have many more fans and can set up a dedicated PSU to have them run
>this would allow for suck-and-pull airflow - more airflow! so could i tape up my whole computer and have an "intake" where it is the "O" and have the fans inside pull air in through this hole? because then the air would be moving fast and so it would be cool, and taking it from the outside also (like this "0" draining out the water from this intake that is the airflow)
would it be better to have a box on top of this fan so that this "computer" can then be more closed? or open air? for this airflow
can i use fire at all? can... wait - this is the most important question
if you only read one line then
>can i have the exhaust (hot air out) of the intake blow to a small section of the highest point in the slope to make it hot? would this make the hot air go there more? from the fast current of air still, and to make it more focused make it so that any stray/hanging air goes to this hot point?
